Heco BellaDonna Series, Руководство пользователя / Гарантийный талон

Страница: 6 / 32

6
Dear HECO Customer,
Congratulations on your fine new loudspeakers and thank you very much for choosing HECO! You
have made an excellent choice. The high-quality speakers produced by HECO are renowned all over
the world.
Please study the instructions and information below carefully before using your new loudspeakers.
INCLUDED IN DELIVERY
• 2 speaker stands, pre-assembled
• 8 metal spikes with lock nut
• 8 washers with rubber insert
• 8 fixing screws M6 x 30 mm
• Allen key
The BellaDonna Stand speaker stand has been specially developed for the HECO BellaDonna
loudspeakers. The sturdy stand provides a secure base and optimal setup height for the speakers.
ASSEMBLY
SPIKE MOUNTING
Carefully remove the stands from the packaging and first place them on the floor with the large plate
facing up.
First mount the four metal spikes by screwing them into the four threaded inserts in the base plate. (Fig. 1)
Now place the stand with the base plate facing down in the desired position. Please note the installation
instructions set out in the operating instructions for the speakers.
To protect the floor, the washers can be placed under the metal spikes with the rubber insert pointing
downwards.
ADJUSTING THE SPIKES
The metal spikes are height adjustable. This allows any unevenness in the floor to be leveled out,
guaranteeing a firm and secure base for the speaker. To do this, loosen the lock nut and adjust the
spike by turning it. Once the right setting has been found, tighten the lock nut again.
REMOVING THE BELLADONNA LOUDSPEAKER FEET
Before the speaker can be mounted on the stand, the speaker’s flat aluminum feet must first be
removed. To do this, please loosen the screws on the feet with the Allen key and remove them. (Fig. 2)
MOUNTING THE SPEAKER ON THE STAND
Now place the BellaDonna speaker in the center of the upper plate of the stand so that the speaker
protrudes equally over the plate on all sides. In this position, the holes in the plate are aligned with the
threaded inserts in the bottom of the speaker.
Now screw the upper plate to the speaker from below using the M6 x 30 mm screws (provided). Use
the Allen key provided to do this. (Fig. 3)