E01—start failure
(
Starting directive is sent to controller, but generator fails to start. The generator
will not try to start generator before fault is cleared
)
E02—voltage > 250V (The data is detected 5 seconds after generator starts)
E04—frequency >67Hz (The data is detected 5 seconds after generator starts)
E05—frequency<53Hz (The data is detected 5 seconds after generator starts)
E06—battery voltage >19V (The data is detected before starting,. The generator can not start if
fault is inspected)
E07—battery voltage <10.5V (The data is detected before starting. The generator can not start if
fault is inspected)
E08—low oil pressure
1-4.3 Fault code
4