blades, enters the flame steady plate and the burner, supplying additional
oxygen to the burner, making the burning more efficient. The fan dissipates heat
from the burner interior to the outside, so that the burner surface will not
overheat.
The spark plug stops working after 12 seconds of sparking.
Maintenance
Notice: Before maintenance shut off the
heater and pull out the plug.
Never maintain the heater with fuel in
the tank.
When the fuel filter gets dirty, replace it
with a new one.
Use a screw driver to open the side plate
and pull out the fuel pipe from the filter.
Use a screw driver to remove the fuel
plug from the tank and pull down the
transparent fuel pipe.
Remove the old filter and replace with a
new one. Re-install the transparent fuel
pipe and fuel outlet plug. Insert it in the
tank and connect the fuel inlet pipe –
see above figure 7.
Check the fuel tank.
When there is waste and water in the
tank, clean and drain the fuel tank.
How to drain the fuel tank – see above
figure 8
Put the heater on the working table and
place an oil container under the fuel
tank.
Use a spanner to loosen the drain screw
and release the water and waste inside the tank.
After draining tighten the drain screw again and wipe clean any spilt water
or oil.
10
Figure 8
Figure 7
A fuel filter
B fuel outlet plug
C transparent
fuel pipe
HSFAH30_instructions 13/7/15 12:55 Page 10
