Heatmiser Slimline-RF V3, Инструкция по эксплуатации

Страница: 16 / 36

15
Wireless Series
Pairing With the RF-Switch
Step 1, On the RF-Switch:
• Press and hold the CH1 button for 5 seconds, the CH1 light will start flashing and pairing
mode is now active on the RF-Switch.
Once the RF-Switch detects the pairing signal from the Slimline-RF V3, the CH1 light will turn off.
Step 2, On the Slimline-RF V3
• Turn Off the thermostat by, holding down the Power button for 3 seconds...........
• Now hold down the H button for 3 seconds unit you see P1 in the top right hand
corner of the display....................................................................................................................
• Tap H button once while P1 is shown to start a 99 second countdown...................
• During the countdown the thermostat will transmit a signal and flash the RF
icon at the top left hand corner of the display....................................................................
If pairing is successful, the countdown will jump straight to 00 followed by a blank
screen.
• Press the Power button on the thermostat once to turn the unit back On..............
If in mode 02, the hot water timer will automatically be paired to the HW channel .
If pairing is unsuccessful, eliminate a possible signal issue by repositioning the thermostat
closer to the receiver and repeat the pairing process again.