Heatmiser Slimline-RF V3, Инструкция по эксплуатации

Страница: 13 / 36

12
Model: Slimline-RF V3
Pairing with the UH8-RF V2 Wiring Centre
Step 2, On the Slimline-RF V3:
• Turn Off the thermostat by, holding down the Power button for 3 seconds...........
• Now hold down the H button for 3 seconds unit you see P1 in the top right hand
corner of the display....................................................................................................................
• Tap the H button once while P1 is shown to start a 99 second countdown...........
• During the countdown the thermostat will transmit a signal and flash the RF
icon at the top left hand corner of the display....................................................................
If pairing is successful, the countdown will jump straight to 00 followed by a blank
screen.
• Press the Power button on the thermostat once to turn the unit back On..............
If in mode 02, the hot water timer will automatically be paired to the HW channel .
If pairing is unsuccessful, eliminate a possible signal issue by repositioning the thermostat
closer to the receiver and repeat the pairing process again.
Step 1, On the UH8-RF V2:
• Press and hold the pairing button on the desired channel until the output indicator LED
flashes. Pairing mode is now active on the UH8-RF V2.
Once the UH8-RF V2 detects the pairing signal from the Slimline-RF V3 the output light will turn off.
Note: You can pair the Slimline-RF V3 to multiple channels on the UH8-RF V2.