Do not use this room heater if any part has been under water. Immediately call a qualified service
technician to inspect the room heater and to replace any part on the control system and any gas
control which has been underwater.
This room heater is for installation in a solid fuel burning fireplace or listed unvented firebox enclo-
sure only.
A fireplace screen must be in place when the appliance is operating and, unless other provisions for
combustion air are provided, the screen shall have an opening (s) for introduction of combustion air.
Any glass door should be fully opened when the appliance is in operation.
Solid fuels shall not be burned in a fireplace in which an unvented room heater is installed.
Any outside air ducts and/or ash dumps in the fireplace should be permanently closed at time
of appliance installation.
Clearances around air openings of fireplace must be kept clear. Do not stack anything in
front of air vents or fireplace openings.
This appliance is equipped for (natural or Propane) gas. Field conversion is not
permitted. The appliance may be returned to the manufacture for conversion.
W
A
R
N
IN
G
This appliance is for installation only in a solid fuel burning masonry or UL 127 Factory-built
fireplace or in a listed unvented firebox enclosure. It has been design certified for these
installations. Exception: DO NOT install this appliance in a factory-built fireplace that includes
instructions stating it has not been tested or should not be used with unvented gas logs.
W
A
R
N
IN
G
Page 3
Important safety information cont
The installation of appliances designed for manufactured home or mobile home
installation must conform with Manufactured Home Construction and Safety Standard,
Title 24 CFR, Part 3280, in the United States, or when such standard is not applicable,
ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard.
