08/04
30803 Rev X
3
CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
A. APPLIANCE SPECIFICATIONS & CERTIFICATIONS
1. U.S. and Canada Certification
The Caliber Series Gas Appliance has been tested in accordance with the
ANSI standard Z21.88-2000
in the United
States, the current
CSA 2.33-2000
,
IR41
,
P4
, and
IR55
in Canada, and has been LISTED by Underwriters Laboratories
Inc. for installation as described in this manual. All components are UL, AGA, CGA or CSA safety certified.
2. Local Codes
This installation must conform with local codes. In the absence of local codes, comply with the
National Fuel Gas
Code ANSI Z223.1-latest edition
in the U.S.A., and the
CAN/CGA B149, Installation Codes
in Canada.
The Caliber Series gas appliance has been tested and listed for use in manufactured housing (mobile homes).
These installation instructions conform with the
Manufactured Home Construction and Safety Standard
,
Title 24
CFR, Part 3280
, or when such a standard is not applicable, the Standard for
Manufactured Home Installations
,
ANSI A225.1
.
For assistance during installation contact your local dealer or contact Heatilator Technical Services Department,
Hearth & Home Technologies, 1915 W. Saunders Street, Mt. Pleasant, Iowa 52641, 1-800-927-6841.
HEATILATOR® is a registered trademark of Hearth & Home Technologies.
Tools and building supplies normally required
for installation:
Saw
Framing material
Pliers
Appliance surround
Hammer
Caulking material
Phillips screwdriver
Gloves
Tape measure
Framing square
Plumb line
Electric drill and bits
Level
Wall-finishing
Safety glasses
materials
Non-corrosive leak-check solution
Note:
Minimum and maximum clearances must be
maintained at all times. Illustrations throughout these
instructions reflect typical installations and are for de-
sign purposes only. Actual installation may vary slightly
due to individual design preferences.
The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.
3. Glass Specifications/Certifications
Heatilator gas appliances manufactured with tempered glass may be installed in hazardous locations such as
bathtub enclosures as defined by the CPSC. The tempered glass has been tested and certified to the requirements
of
ANSI Z97.1-1984 and CPSC 16 CFR 1202
. (Safety Glazing Certification Council
SGCC# 1595
and
1597
. Architectural
Testing, Inc. Reports
02-31919.01
and
02-31917.01
.)
This statement is in compliance with
SPCS 16 CFR Section 1201.5 “Certification and labeling requirements”
which refers to
15 USC 2063
stating, “…Such certificate shall accompany the product or shall otherwise be furnished
to any distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory. Please contact your dealer or distributor to order.
WARNING!
This appliance is tested and listed for use only with the optional accessories listed in these
instructions. Use of optional accessories not specifically tested for this appliance could
void the warranty and/or result in a safety hazard.
f i r e - p a r t s . c o m