13
August 23, 2019
7074-801C
HEATILATOR ECO CHOICE CAB50
L. Clear Space
Mantel:
Avoid placing candles and other heat-sensitive
objects on mantel or hearth. Heat may damage
these objects.
Fire Risk.
Do NOT place combustible objects in front of
the appliance. High temperatures may ignite
clothing, furniture or draperies. Maintain a
minimum clearance of 3 feet (914mm) in front
of appliance.
WARNING
Fire Risk.
Keep combustible materials, gasoline and
other flammable vapors and liquids clear of
appliance.
WARNING
•
Do NOT store flammable materials in the
appliance’s vicinity.
• DO NOT USE GASOLINE, LANTERN FUEL,
KEROSENE, CHARCOAL LIGHTER FLUID OR
SIMILAR LIQUIDS TO START OR “FRESHEN UP”
A FIRE IN THIS Appliance.
• DO NOT BURN GARBAGE OR FLAMMABLE
FLUIDS SUCH AS GASOLINE, NAPHTHA OR
ENGINE OIL.
• DO NOT USE CHEMICALS OR FLUIDS TO START
THE FIRE.
• Keep all such liquids well away from the appliance
while it is in use.
• Combustible materials may ignite.
NOTICE:
Clearances may only be reduced by means
approved by the regulatory authority
having jurisdiction.
M. Thermostat Operation
There is a 4 screw terminal block located on the back lower
left corner of the stove directly above the power cord inlet.
The center 2 screws are for the thermostat wires
(see
Figure 11.1 on page 11)
.
The appliance comes standard with a wall thermostat and
25’ of wire. If you need to run more than 25’ make sure
you use a continuous strand of 18 to 22 gauge thermostat
wire. For optimum performance your thermostat should be
located on an inside wall approximately 5’ up from the floor.
How to Install Your Wall Thermostat
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
2. Connect your thermostat wire to the W and R terminals
(see Figure 11.2 on page 11).
3. Screw the backer plate to the wall using the hardware
included.
4. Snap the thermostat to the backer plate
5.
Connect the wires to the 2 center screws on the
terminal block on the back of the product
NOTE:
2 AA batteries are included with the thermostat
and must be installed before the appliance can be
operated
(see Figure 11.3 on page 11)
.
Battery Installation and Replacement
Install fresh batteries immediately when the REPLACE
BATTERY warning begins flashing. The warning flashes
about two months before the batteries are depleted. Even if
the warning does not appear, you should replace batteries
once a year.
If batteries are inserted within two minutes, the time
and day will not have to be reset. All other settings are
permanently stored in memory.
Shock hazard.
•
Do NOT remove grounding prong
from plug.
•
Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
CAUTION
Содержание ECOCHOISE CAB50-C
Страница 32: ...32 August 23 2019 7074 801C HEATILATOR ECO CHOICE CAB50 Date of Service Performed By Description of Service ...
Страница 33: ...33 August 23 2019 7074 801C HEATILATOR ECO CHOICE CAB50 Date of Service Performed By Description of Service ...
Страница 34: ...34 August 23 2019 7074 801C HEATILATOR ECO CHOICE CAB50 Date of Service Performed By Description of Service ...