Heat & Glo • CFL-24NG/LP, CFL-24NG/LP-B, CFL-24NG/LP-C • 481-926 Rev. E • 9/21
1
LOG PLACEMENT
INSTRUCTIONS
Log Set Assembly:
Models: CFL-24NG/LP
CFL-24NG/LP-B
CFL-24NG/LP-C
33
11
44
22
55
33
11
88
10
10
66
44
77
22
99
55
BRACKETS
(Use to place log #5)
LOG #1 & #2: (SRV481-766)
Set logs #1 and 2 in front of the burner. Rest the bottom
two notches over the extended material of the burner legs.
Slide it towards the burner until it comes in contact with
the burner.
LOG #3 & #4: (SRV481-755)
Set logs #3 and #4 between the grate and logs #1 and 2
with the bark detail toward the outside. Logs #3 and #4
should be even with logs #1 and #2 from one side to the
other. Slide grate to hold log in place.
LOG #5: (SRV481-701)
This log sits toward the back on top of the brackets located
on the right and the left. The two notches on the bottom of
the log should rest over these brackets. The back of this
log should line up with the back end of the brackets.
FLAT AREA (Use to place log #6)
LOG #6: (SRV481-705)
Set log #6 on the top of log #1 and the burner toward the
left by following the flat area mark (on log #1). Make sure
that the log will clear the ports on the top of the burner.
FLAT AREA (For log #7)
66
BURNER STYLE MAY VARY
Follow the instructions for log placement using figures
and instructions below.
Use the “flat areas” indicated in
the photos to guide you through the process. Use the
log numbers to identify the logs. Check to make sure
the tabs on the side of burner legs are bent outward. Set
log grate by resting it down and sliding it toward burner.
Make sure right and left grate bars slide on outside of
burner legs between tabs.
CAUTION: Carefully remove the logs from the
packaging. Logs are fragile!
NOTICE: To simplify the installation process,
positively identify each individual log before
beginning installation.
NOTICE: Burner styles may vary.