Heatilator CD4236-MOD, Руководство пользователя

Страница: 17 / 27

17
Heatilator • CD4236-MOD, CD4842-MOD Owner’s Manual • 2241-902 Rev. C • 11/15
Burner Ignition and Operation
Frequency: Annually
By: Quali fi ed Service Technician
Tools needed: Protective gloves, vacuum cleaner, whisk
broom, fl ashlight, voltmeter, indexed drill bit set, and a
manometer.
• Verify burner is properly secured and aligned with pilot
or igniter.
• Clean off burner top, inspect for plugged ports, corrosion
or deterioration. Replace burner if necessary.
• Replace Glowing embers with new dime-size pieces.
DO NOT block ports or obstruct lighting paths. Refer to
Section 4 for proper ember placement.
• Verify batteries have been removed from battery back-up
IPI systems to prevent premature battery failure or
leaking.
• Check for smooth lighting and ignition carryover to all
ports. Verify that there is no ignition delay.
• Inspect for lifting or other fl ame problems.
• Verify air shutter setting is correct. See Installation
Manual for required air shutter setting. Verify air shutter
is clear of dust and debris.
• Inspect ori fi ce for soot, dirt and corrosion. Verify ori fi ce
size is correct. See Service Parts List for proper ori fi ce
sizing.
• Verify manifold and inlet pressures. Adjust regulator as
required.
• Inspect pilot fl ame pattern and strength. See Figures 4.2
for proper pilot fl ame pattern. Clean or replace ori fi ce
spud as necessary.
• Inspect IPI fl ame sensing rod for soot, corrosion and
deterioration. Polish with fi ne steel wool or replace as
required.
• Verify that there is not a short in fl ame sense circuit
by checking continuity between pilot hood and fl ame
sensing rod. Replace pilot as necessary
Figure 4.2 IPI Pilot Flame Patterns
Figure 4.4 Glass Panel Removal
D. Glass Refractory, Base Pan, Burner and
Valve Assembly Removal
It may become necessary to remove the glass panels,
base pan, burner and valve assembly. This task should
be performed by a quali
fi ed service technician.
Figure 4.3 Remove Glass Panel Retainers
REAR PANEL RETAINER
SIDE PANEL RETAINERS
1. Remove the media.
2. Remove the side glass panel retainers (if equipped).
See Figure 4.3. Slide the side glass panels out of the
appliance as shown in Figure 4.4.
3. Remove the rear glass panel retainer (if equipped),
shown in Figure 4.3, and lift the rear glass panel out of
the appliance.