-7-
598-1187-02
Controlling Non-Motion Sensing
Fixtures
❒
When wiring to additional standard fixture
only:
Strip the motion sensor's
red
wire and
connect to the standard light's
black
wire.
Connect all white wires together. Total fixture
ratings must not exceed 1000 Watts (8.3 A).
NOTE:
All wiring between fixtures should be run
in accordance with the National Electrical
Code (Canadian Electrical Code in Canada)
through conduit or another acceptable means.
Contact a qualified electrician if there is any
question as to the suitability of the system.
❒
This fixture is provided with a sensor rated
for 1000 Watts. Since the fixture is only rated
300 Watts, 700 Watts of additional load may
be controlled by this sensor.
❒
When determining what a fixture is rated for,
do not simply look at the rating on the lamp in
the fixture. Look at the marking which speci-
fies the maximum lamp wattage for which the
fixture is suitable.
❒
Once you have selected the fixtures to be con-
nected and determined their maximum ratings,
add these ratings up. For instance, if you have
3 fixtures rated 100 Watts, 150 Watts, and 75
Watts respectively, you have a total load of 325
Watts.
(Standard)
RED
from
JourneyMan
®
to
BLACK
from
Fixture
BLACK
from
Switch to
BLACK
from
JourneyMan
®
Wiring to a Motion Light & Standard Fixture
WHITE
from Line
to
WHITE
from
JourneyMan
®
WHITE
from Line
to
WHITE
from
Fixture
