7
595-5628-08
SPECIFICATIONS
Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
[varies with surrounding
temperature]
Sensing Angle . . . . . Up to 180°
Electrical Load . . . . . See rating on fixture
for maximum wattage
Sensor Capacity . . . Up to 360 Watts (3.0 A.)
Maximum Tungsten
Incandescent
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
MANUAL MODE
Time Delay . . . . . . . 1, 5, 10 minutes
D
ual
B
rite
®
Timer . . . Off, 3, 6 hours, dusk-to
dawn
HeathCo LLC reserves the right to discontinue
products and to change specifications at
any time without incurring any obligation
to incorporate new features in products
previously sold.
TROUBLESHOOTING GUIDE
SYMPTOM
Light stays on
continuously.
Light flashes
on and off.
POSSIBLE CAUSE
1. The sensor is pointed toward
a heat source like an air
vent, dryer vent, or brightly-
painted heat-reflective surface.
(Reduce sensitivity.)
2. Light control is in Manual Mode.
(Switch to Auto.)
3. Light control is in D
ual
B
rite
®
mode.
4. Sensitivity is set too high. (Re-
duce sensitivity.)
1. Light control is in the Test
mode and war ming up.
(Flashing is normal under
these conditions).
2. Heat being reflected from other
objects may be affecting the
sensor. (Reduce sensitivity.)
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if this is
a new installation.
1. Light control may be installed in
a relatively dark location.
2. Light control is in Test. (Set
control switch to an ON-TIME
position.)
1. Light control may be sensing small
animals or automobile traffic
(Reduce sensitivity).
2. Sensitivity is set too high. (Re-
duce sensitivity.)
SYMPTOM
Light will not
come on.
Light comes on
in daylight.
Light comes on
for no apparent
reason.
