3
595-5575-09
Mount the Light Control
❒
Place the mounting bolt through the front of the
junction box cover. Push the small gasket hole over
the mounting bolt.
❒
Make sure the wire connectors and wires are inside
the junction box. Align the mounting bolt with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
❒
Push the rubber plug firmly into place.
❒
If not installed on a weatherproof box,
caulk the
wall plate and mounting surface
with silicone.
❒
Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180°
from the factory setting.
Keep lamps at least
1" (2.5 cm) from the
sensor.
Black
to
Black
White
to
White
Gasket
Connect green or bare copper wire(s) in the fixture
to green ground screw and ground wire in junc-
tion box.
Note:
All ground wires shown as green
in above illustration.
❒
Remove the existing light fixture.
❒
Install mounting strap to junction box using screws
appropriate for your junction box.
❒
The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
❒
Thread all fixture wires through the large holes in
the gasket as shown.
❒
Connect the junction box wires to the light fixture
wires as shown. Twist together and secure with
wire connectors.
Rubber Plug
Mounting Bolt
Bulb Installation
NOTE:
Lamps are included, but you will need to install
them
NOTE:
When re-lamping,
turn power off
and let the
fixture cool.
❒
Open glass covers. To remove the old bulb push
the bulb towards the right until the left side of the
bulb is clear of the left socket.
❒
To install a bulb, push the bulb into the right socket
so the bulb fits completely into the left socket.
❒
Check that the bulb is seated properly.
❒
Close the glass covers.
Push the rubber plug
over the mounting bolt.
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
CAUTION: Do not cut any wires with factory
installed wire connectors.
Mounting Strap
