Heath Zenith 7162, Руководство пользователя

Страница: 4 / 24

4
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
208824-01
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
3. Press up on the battery compartment cover locking tab and swing
the cover out and down to remove (see Figure 4).
4. This light fixture is shipped with the internal, rechargeable, Li-ion
battery disconnected from the light.
• Gently press down on the wiring harness as shown by arrow
1 (see Figure 5).
• Slide the mail connector into the female connector as shown
in arrow 2 (see Figure 5).
IMPORTANT:
Once the the solar battery harness is connected,
there will be no need to touch this harness again.
5. Install three, 1.5V “C” batteries (not included) into the battery
compartment (see Figure 6). Make sure the polarity of the bat-
teries is correct.Replace the battery compartment cover.
IMPORTANT:
The “C” batteries are used when the rechargeable
solar battery is depleted. When the “C” batteries are depleted, a
red LED will flash inside the motion sensor and the “C” batter-
ies will need to be replaced.
6. Slide the rear of the light fixture down onto the mounting plate
until it snaps into place (see Figure 7).
Mounting the Solar Panel
1. Place the solar panel against the mounting surface and mark the
mounting holes (see Figure 8).
• If mounting to a wooden surface, drill two 3/32 in. holes into
the mounting surface. Install the two mounting screws through
the base and into the mounting surface.
• If mounting to wall board or brick, drill two 7/32 in. holes
into the mounting surface. Insert the wall anchors and attach
the base using the two mounting screws.
IMPORTANT: Caulk around the base and on top of the screw
heads after installation.
OPEN PRESS
TO CL
OSE
OPEN PRESS
TO CL
OSE
1
2
1
2
W
UP