13
405 E. Santa Clara St., Arcadia, CA 91006-7218
O
: (626) 599-8566
•
F
: (626) 599-9567
•
Once you have completed the above mentioned procedures, the unit is ready to heat fluid to
the required temperature. No further calibration or set up is necessary for the controls in order
to process the fluid at the correct temperature.
•
The automatic temperature controller included with this unit uses a combination of PID and
fuzzy logic. Due to the manner in which this unit operates, it does not require regular re-
calibration or maintenance. The only sort of calibration that is required is the Auto-Tuning
process. This process is used to provide the controller with the reference values for the P, I,
and D parameters of the controller. The Auto-Tuning process only needs to be completed
upon the initial operation of the unit, if the set-point of the unit has been changed by a large
amount, or if system stability is unacceptable. To Auto-Tune your unit please refer to page
19 of the accompanying controller manual for the details of this procedure.
