2. Piping the valve as shown below is considered the "ALTERNATE" configuration.
Ensure to follow the port letter designation or the valve flow direction label.
Mounting the Actuator to the ETV Valve
3. Reference pages
30
through
32
for recommended system piping of the ETV valve
Figure 5:
"Alternate" ETV valve
configuration
2. Before mounting the Actuator to the ETV valve, manually lower the Actuator as shown in Figure 7.
a. Lower the Manual Tab to place the Actuator in Manual Override mode.
b. Turn the Manual Tab counter-clockwise to drive the threaded shaft to the full lower position.
c. Raise the Manual Tab to place the Actuator in Normal Operation mode.
1. Before mounting the Actuator to the ETV valve, manually close the ETV valve by pushing down on the
valve stem as shown in Figure 6.
Figure 6:
Manually closing the ETV valve
059305-00 Rev. D
Heat-Timer Corp.
Installation Instructions 15
NOTE
: Reference page 29 for Dip Switch settings based on valve installation configuration
Содержание ETV Platinum Plus
Страница 9: ...ETV Platinum Plus Stainless Steel Valve Dimensional Specifications 9 059305 00 Rev D Heat Timer Corp...
Страница 31: ...Piping Diagrams 31 059305 00 Rev D Heat Timer Corp Figure 14B Two Mixing Valves and a TMC Safety Valve...
Страница 54: ...059305 00 Rev D Heat Timer Corp Notes 54 ETV Platinum Plus Installation and Operation Manual...
Страница 55: ...059305 00 Rev D Heat Timer Corp Notes ETV Platinum Plus Installation and Operation Manual 55...
