3
Revised 2019
MACHINE TECHNOLOGY & COMPONENTS
HOT ROD HEAT UP
First, place the desired film in cradle mounts and thread the film up through the machine according to the diagram on
the right side of the unit.
Plug in the power cord and there is a switch on the right side of the electrical box that you may turn on.
Turning on the unit will allow the film cutting rod to begin to heat, it will take a few minutes to get up to optimal cutting
temperature.
Caution:
The film cutting rod will continue to heat while the wrapper is turned on so contact other than the film for pack-
ages should be avoided.
PHOTOEYE ACTUATED HEATER
The heat cycle in the seal plate begins when a package is placed in front of the photo-eye on the seal plate.
ENERGY SMART® TECHNOLOGY
The Energy Smart® Wrapper is an innovative system that incorporates an “Instant On” seal plate with the ability to go
from ambient to sealing temperature in a matter of seconds. The wrapper uses a photo eye to see when a store associate
is wrapping a package and automatically initiates a heat cycle (approximately 3 seconds). After the cycle the wrapper
stops heating to conserve energy.
Heat Seal tests all seal plates before they ship. Thermal expansion in the seal plate layers will create a wrinkle effect –
this is normal.
1
3
2
*scale pictured is
not included
4
OPERATOR INDICATOR LIGHT
A dual-colored light will change from yellow, when
the plate is heating, to red when the plate is at film
sealing temperature.
