Heat-N-Glo CFX-TV36B, Руководство по установке

Страница: 9 / 17

9
3
Installing the Fireplace
Step 1. Locating the Fireplace
The diagram below shows space and clearance require-
ments for locating a fireplace within a room.
Minimum Clearances
from the Fireplace to Combustible Materials
Inches mm
Glass Front ........................ 36 .................... 914
Floor ................................... 0 ....................... 0
Rear ...................................1/2 ..................... 13
Sides .................................1/2 ..................... 13
Top ...................................... 4 ..................... 102
Ceiling* .............................. 50 ....................1270
Figure 2. Fireplace Dimensions, Locations,
and Space Requirements
Clearance Requirements
The top, back, and sides of the fireplace are defined by
stand-offs. The minimum clearance to a perpendicular wall
extending past the face of the fireplace is one inch (25
mm). The back of the fireplace may be recessed 18 3/4
inches (476 mm) into combustible construction.
Figure 3. Framing Dimensions
The distance from the unit to combustible construction
is to be measured from the unit outer wrap surface to
the combustible construction, NOT from the screw
heads that secure the unit together.
Minimum Clearances from the Class B Chimney Vent
Pipe to Combustible Materials is 1 inch (25mm) all
around the pipe.
Step 2. Framing the Fireplace
Fireplace framing can be built before or after the fireplace is
set in place. Framing should be positioned to accommo-
date wall coverings and fireplace facing material. The dia-
gram below shows framing reference dimensions.
CAUTION: MEASURE FIREPLACE DIMENSIONS AND
VERIFY FRAMING METHODS AND WALL COVERING
DETAILS BEFORE FRAMING.
* The clearance to the ceiling is measured from the top
of the unit, excluding the standoffs (see Figure 11).
Framing should be
constructed of 2 X 4
lumber or heavier.
A B C D
36 3/4” 35 13/16” 19 3/4” 29 15/16”
NOTE: You must place the supplied (required) non-
combustible board on the top front face of the unit once the
unit is in place. See Figure 11.