18
Positioning the Logs
If the gas logs have been factory installed they should
not need to be positioned.
If the logs have been packaged separately, refer to
the installation instructions that accompany the logs.
Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
Placing the Ember Material
Ember material is shipped with this gas fireplace:
The bag containing the Glowing Embers (050-721)
is standard glowing ember material.
To place the ember material:
Pull the four glass latches out of the groove on the
glass frame.
Remove the glass door from the unit.
Cover the top of the burner with a single layer of
ember material. For best performance do not
place embers on the ports on the rear of the
burner.
Save the remaining ember materials for use during
fireplace servicing.
Replace the glass door and a front trim door on the
unit (see Replacement Parts Section of the manual.)
Pull out and latch the glass clips into the groove on
the glass frame.
Installing the Trim
Combustible materials may be brought up to the
specified clearances on the side and top front edges of
the fireplace, but
MUST NEVER
overlap onto the front
face. The joints between the finished wall and the
fireplace top and sides can only be sealed with a 300
°
F. (149
°
C) minimum sealant.
WARNING: WHEN FINISHING THE
FIREPLACE, NEVER OBSTRUCT OR
MODIFY THE AIR INLET/OUTLET GRILLES IN
ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-
combustible materials can be used to cover up the gap
between the sheet rock and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles.
When overlapping on both sides, leave enough space
so that the bottom grille can be lowered and the trim
door removed.
Step 11
Installing Trim,
Logs, and
Ember Material