Heat Design FW5C, Инструкция по установке и эксплуатации

Страница: 6 / 14

5
HD02 01/10/11
If necessary a hole must be opened up into the flue way above the fireplace in order to fit the appliance to
the flue correctly. Please consult HETAS recommended fitting methods if in doubt. It is
essential that all
connections between the stove and chimney-flue are sealed and made airtight with sealing rope, clamping
rings and/or fire cement or heat resisting cement where required.
Both the chimney and flue pipe must be accessible for cleaning and if ANY parts of the chimney cannot be
reached through the stove (with baffle removed), a soot door must be fitted in a suitable position to enable
this to be done.
4.5 Fixing
Fix the stove to the back hearth using suitable non-combustible fixings through the base of the outer firebox.
If necessary screw the outer firebox to the back-panel by fixing the top or side flanges using suitable non-
combustible fixings.
4.6 Material Clearances
Safety Distances from Combustible Surfaces:
Model
Shelf Side
(outer edge of trim)
FW5C 250mm 350mm
In addition it is strongly recommended that any furniture or other combustible materials are kept at least
900mm clear from the front of the stove.
Distances from NON-combustible materials:
The stove can be recessed in a suitable sized non-combustible fireplace but a permanent free air gap of at
least 50mm must be left around the sides and top of the stove to obtain reasonable heat output and for access
to the stove for removal and maintenance. A clearance of 150mm will give a better heat output
To conform with building regulations the fireplace recess walls should be at least 200mm thick or each rear
leaf at least 100mm thick in the case of a cavity wall at the rear. If these dimensions are not met further
protection for any combustible materials must be provided. The walls of the fireplace recess and the hearth
must be made of non-combustible material.
4.7 Hearths:
The FW5C stove require a 125mm thick non-combustible constructional hearth beneath them to protect the
building, this can include any solid non-combustible floor. A non-combustible superimposed hearth forming
an apron of at least 225mm at the front of the stove and 150mm on either side must also be provided. The
superimposed hearth must not be less than 12mm thick and must have a clearly defined edge (change of
level) to discourage placing of any combustible materials on or partially over it.
The appliance shall be installed on a floor with adequate load-bearing capacity. If the existing construction
does not meet this requirement, suitable measures (e.g. load distributing plate) should be provided to achieve
it.
4.8 Commissioning and Handover
Upon completion of the installation, allow a suitable period of time for any fire cement and mortar to dry
out. A small fire may then be lit and checked to ensure the smoke and fumes are taken from the stove up the
chimney and emitted safely to atmosphere.
Advise the customer not to run the stove at full output for at 3 – 4 days. Explain that the stoves can provide
much more or less than their rated heat outputs depending upon how they are burnt and fuels and fuel loads
used.