background image

  

1

!

 

  

WARNING

SEALED COMBUSTION

DOWNFLOW GAS FURNACE
MODELS: 

G18D SERIES, 

SIZES: 60, 70, 77, 90                                                             

FOR INSTALLATION IN:

 MANUFACTURED (MOBILE)                                                              

HOMES, RECREATIONAL VEHICLES, PARK MODELS,                                                                           

MODULAR HOMES AND BUILDINGS.

 GENERAL INFORMATION

These down flow sealed combustion furnaces install in 

Manufactured Homes, Recreational Vehicles or Modular 

Construction. The furnaces conform to Part 3280 (a)(2) 

of HUD Manufactured Homes Construction and Safety 

Standards. They must be installed only with listed RJ-Roof 

Jack, Sealed Combustion venting system.

NOTE:

 These instructions are intended to assist qualified 

individuals experienced in the installation of heating 

equipment.         

Some state and local codes require installation 

personnel to be licensed. Read all instructions before 

starting the installation.

 SAVE THIS MANUAL

NOTICE

 – Furnace set-up and any adjustment needed is 

responsibility of the installer/retailer/ contractor and is 

not covered by the furnace manufacturers warranty.

CHECKLIST: FURNACE START-UP

1. Has furnace roof jack crown been correctly installed.

2. Has the furnace gas valve and burner orifice 

  been cleaned.

3. Is the gas line outlet pressure set for the fuel used.

4. If the home uses a crossover air connector duct, is it

    installed per home builders installation instructions.

5. Has furnace been operated through complete 

  heating cycle.

RISK  OF  FIRE  OR  ELECTRICAL  SHOCK

Only  qualified  service  personnel  shall  be  used  to 

install  and  provide  maintenance  of  this  furnace.

CONTENTS 

PAGE 

General Information...........................................1

Specifications ...................................................2

Safety Conditions ..............................................3

Installation Standards .........................................3

High Altitude Installation ....................................3

Installation Clearances .......................................3

Return Air ...................................................... 4-5

Alcove & Closet Installation ................................5

Air Distribution Systems ......................................6

Duct Connector/Base .........................................6

Install Furnace ...................................................7

Roof Jack Selection ............................................7

Cut Opening & Install Roof Jack ..........................8

Installing In Snow Regions ..................................8

Roof Jack On High-Pitch roof ...............................8

Connect Power Supply Wires ..............................9

Wall Thermostat ................................................9

Connect Thermostat Wires ..................................9

Gas Piping .................................................. 9-10

High Altitude Deration Chart .............................11

Final Procedure ...............................................12

Furnace & Air Conditioner Installation ................12

Blower Performance Chart ................................13

Wiring Diagrams ....................................... 14-16

INSTALLATION INSTRUCTIONS

CAUTION: READ ALL SAFETY GUIDES 

BEFORE INSTALLING THIS GUIDE

Gas-Fired

LISTED

UL

®

?

?

?

?

?

Installation Instructions 

MGD-B SERIES GAS FURNACE

 

Heat Controller, Inc.

SAVE THIS MANUAL

1

Содержание MGD60-E3B


















Отзывы: