6
Heat & Glo • SL-5/5LP-IFT, SL-7/7LP-IFT, SL-9/9LP-IFT Owner’s Manual • 2632-981 Rev. D • 1/21
A. Appliance Certification
2
2
Product Specific Information
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
B. Glass Specifications
Hearth & Home Technologies appliances manufactured
with tempered glass may be installed in hazardous lo-
cations such as bathtub enclosures as defined by the
Consumer Product Safety Commission (CPSC). The
tempered glass has been tested and certified to the re
-
quirements of
ANSI Z97.1
and
CPSC 16 CFR 1202
(Safety Glazing Certification Council
SGCC# 1595
and
1597
. Architectural Testing, Inc. Reports
02-31919.01
and
02-31917.01
).
This statement is in compliance with
CPSC 16 CFR Sec-
tion 1201.5
“Certification and labeling requirements”
which refers to
15
U.S. Code
(USC) 2063
stating “…Such
certificate shall accompany the product or shall otherwise
be furnished to any distributor or retailer to whom the
product is delivered.”
Some local building codes require the use of tempered
glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory.
Please contact your dealer or distributor to order.
This product is listed to ANSI standards for “Vented
Gas Fireplace Heaters” and applicable sections of “Gas
Burning Heating Appliances for Manufactured Homes
and Recreational Vehicles”, and “Gas Fired Appliances
for Use at High Altitudes”. Also Certified for Installation in
a Bedroom or a Bedsitting Room.
NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.
This appliance is tested and approved as either supplemen-
tal room heat or as a decorative appliance. It should not be
factored as primary heat in residential heating calculations.
NOTICE:
This installation must conform with local codes.
In the absence of local codes you must comply with the
National Fuel Gas Code, ANSI Z223.1-latest edition in
the U.S.A. and the CAN/CGA B149 Installation Codes in
Canada.
MODELS:
SL-5-IFT, SL-5LP-IFT, SL-7-IFT, SL-7LP-IFT,
SL-9-IFT, SL-9LP-IFT
LABORATORY:
Underwriters Laboratories, Inc. (UL)
TYPE:
Direct Vent Heater
STANDARD:
CSA / ANSI Z21.88:19 • CSA 2.33:19
C. BTU Specifications
Models
(U.S. or Canada)
Maximum
Input BTU/h
Minimum
Input BTU/h
Orifice
Size (DMS)
SL-5-IFT
(NG)
(0-2000
ft
)
21,000
11,250
#44
SL-5LP-IFT
(Propane)
(0-2000
ft
)
18,500
10,000
#55
SL-7-IFT
(NG)
(0-2000
ft
)
25,000
13,000
#42
SL-7LP-IFT
(Propane)
(0-2000
ft
)
23,500
11,500
#54
SL-9-IFT
(NG)
(0-2000
ft
)
30,000
15,500
#38
SL-9LP-IFT
(Propane)
(0-2000
ft
)
30,000
14,500
#52