22
4.Replace the brushes if necessary.
New Motor Brush
Worn Motor Brush
Motor Brush caps
(Fig 26) (Fig 27)
2. Inspect the state of the battery terminals every six months. Make sure that they are
not corroded and the connections are tight. Periodically apply a thin film of
petroleum jelly on the surface of terminals to guard against corrosion.
PERIODICAL CHECKS
1. Make sure to keep the controller clean while protecting it from rain or water.
Never hose off your power scooter or place it in direct contact with water.
2. Keep wheels free from lint, hair, sand and carpet fibers.
3. Visually inspect the tyre tread. If less than 1mm, please have your tyres replaced
by your local dealer.
4. All upholstery can be washed with warm water and mild soap. Occasionally check
the seat and back for sagging, cuts, tears and replace if necessary. Do not store
your scooter in damp or humid conditions as this will lead to mildew and rapid
deterioration of the upholstery parts.
5. All moving mechanism will benefit from simple lubrication and inspection.
Lubricate using petroleum jelly or light oil. Do not use too much oil, otherwise
small drips could stain and damage carpets and furnishings etc. Always perform a
general inspection of the tightness of all nuts and bolts.
6. RHINO controller: Your scooter is fitted with a Rhino controller, which
continuously monitors the operating conditions of your scooter. If it detects a
problem it will indicate with error message by flashing light on the power ON/
OFF light. You must count the number of the flash, and see the list to check what
kind of error has happened according to the number)
Number of
Flashes
Fault
Impact
on
Scooter
Notes
1
Battery
needs
recharging
Will drive
Battery charge is running low. Recharge the batteries
as soon as possible.