52
HEARTLAND Recreational Vehicles, LLC
WARNING
LP-GAS CYLNIDERS SHALL NOT BE PLACED OR STORED INSIDE THE
VEHICLE. LP-GAS CYLINDERS ARE EQUIPPED WITH SAFETY DEVICES
THAT RELIEVE EXCESSIVE PRESSURE BY DISCHARGING GAS TO THE
ATMOSPHERE. FAILURE TO COMPLY COULD RESULT IN DEATH OR
SERIOUS INJURY.
Note
YOUR UNIT’S MANUFACTURER IS NOT RESPONSIBLE
FOR PERSONAL INJURY OR PROPERTY DAMAGE
RESULTING FROM IMPROPERLY MAINTAINED LP
GAS APPLIANCES AND SYSTEMS.
CAUTION
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE WITH LP-GAS ONLY.
DO NOT CONNECT NATURAL GAS TO THIS SYSTEM. SECURELY CAP
THIS INLET WHEN NOT CONNECTED FOR USE. AFTER TURNING ON
GAS, EXCEPT AFTER NORMAL CYNLINDER REPLACEMENT, TEST GAS
PIPING AND CONNECTIONS TO APPLIANCE FOR LEAKAGE WITH SOAPY
WATER OR BUBBLE SOLUTION. DO NOT USE PRODUCTS THAT CONTAIN
AMMONIA OR CHLORINE.
WARNING
NEVER ADJUST THE REGULATOR YOURSELF. HAVE YOUR DEALER
OR AN AUTHORIZED SERVICE TECHNICIAN MAKE ANY REQUIRED
ADJUSTMENTS.
Filling LP Gas Bottles
When your LP gas tank is empty, have it refilled
as soon as possible. There are many LP refueling
stations available. Many RV parks also have LP gas
available. Caution your supplier not to over fill your
tank. Room is required to let the liquid vaporize.
There are approximately 90,000 BTUs of heat
produced from each gallon of LP gas. During extreme
cold temperatures, check fuel tanks frequently to avoid
running out of fuel.
Make sure that all burners and pilot lights are turned
OFF prior to having a gas supplier refill your LP tank.
1. Make sure the arrow on the cylinder selector is
pointed to the full cylinder. (Verify the hose route to
the full cylinder on a split system.)
2. Close the valve on the empty cylinder and remove
the hose from the valve. (NOTE: left hand thread).
3. Loosen the clamp that holds the cylinder in place.
4. Remove the cylinder and have it refilled.
5. Slide the cylinder back in place and tighten clamp.
6. Connect the left-hand hose and tighten securely
The 80 percent STOP FILL VALVE may close the
valve before liquid appears at the 20 percent liquid
level gauge, but if liquid does appear, stop filling
immediately…the tank is filled to its LP capacity.
Note
YOUR LP TANKS MUST BE KEPT FREE OF RUST AT
ALL TIMES. IF RUST DOES DEVELOP, THE TANK
SHOULD BE CLEANED COMPLETELY FREE OF THE
RUST, PRIMED, AND PAINTED WHITE (OR SOME
OTHER HIGHLY REFLECTIVE COLOR) WHICH WILL
HELP TO REDUCE EXPANSION OF THE LP GAS
BECAUSE OF HEAT.
Do not use a wrench to tighten the service valve or
the 20 percent gauge. They are both designed to be
closed leak-tight by hand. If you cannot hand-tighten
the valve, the valve may need repair or replacement.
Consult your gas dealer.
LP Gas Lines
The primary manifold is a black pipe located under
the unit. Copper tubing with flare fittings are used
as secondary lines running to the gas appliances.
Should any lines ever rupture, NEVER attempt to
splice them
. A new line should always be installed.
We recommend any LP gas line services be performed
by your dealer or an authorized service technician.
Always close main valve at LP tank when servicing
Содержание 2014 Bighorn
