HearthStone Tribute 8040, Руководство пользователя

Страница: 8 / 31

Hearthstone Quality Home Heating Products, Inc. ® Tribute Model 8040
5
Installation
U
NPACKING
Hearthstone Stoves packages your Tribute stove
with the greatest care, so that it ships safely. Under
certain circumstances, however, damage can occur
during transit and handling. When you receive your
stove, unpack it carefully, inspecting your stove and
all parts for damage. Also, make sure that all parts
are included in the box. If any parts are damaged or
missing, please contact your dealer immediately.
I
NSTALLING
Y
OUR
S
TOVE
First, you must decide where your stove will reside.
After choosing an appropriate spot, inspect this
location to make sure that the stove will have
enough clearance to combustible materials that
would surround the stove. These combustibles can
include walls, floor, ceiling, fireplace, and chimney.
You must carefully consider the clearances to all of
these combustibles before actually connecting your
stove. When considering these clearances, also
decide the kind of floor the stove will rest on.
Please use this section to plan how to locate your
stove in your particular location. Consider both the
clearances of the stovepipe and the stove itself to
the surrounding combustibles.
The soapstone walls of the Tribute soapstone stove
produce and even, radiant heat. Locate the stove
centrally in your living area to allow the heat to travel
naturally to distant rooms. It is not recommended
that you locate your stove in an uninsulated
basement. The amount of radiant energy required to
heat concrete basement walls is so great that most
of the usable heat is absorbed by them and lost.
Read this chapter to obtain a sound understanding
of how to properly install your stove.
If you use a close clearance connector pipe, it must
be tested to UL standards and listed. Check the
listing of your pipe for actual clearances. The
diagrams
in this manual represent typical
installations, but are specific to the Simpson Dura-
Vent DVL brand. Clearances cannot be reduced
without the use of close clearance connector pipe
and/or by protecting the surfaces per NFPA 211
standards.
C
LEARANCES
T
O
NFPA 211 P
ROTECTED
S
URFACES
You can reduce the clearances to combustible
surfaces by using any National Fire Protection
Agency (NFPA) approved wall protection system.
Please refer to NFPA 211 for specifications and
complete details. You can obtain this information
directly from the NFPA (U.S. Only).
National Fire Protection Agency
Batterymarch Park
Quincy, MA 02269
1-800-344-3555
1-617-770-3000
www.nfpa.org
H
EARTH
R
EQUIREMENTS
A
ND
F
LOOR
P
ROTECTION
Combustible flooring must be protected with a UL
listed hearth pad, or in the absence of fabricate one
with an R-value of 0.6 (slate, marble tiles, or other
noncombustible material can be used for this
purpose). The floor protection must extend beyond
the body of the stove at the minimum as follows:

SIDES 3-
1/2” (20 cm Canada)

REAR 0” (20 cm Canada)

FRONT 16” (45 cm Canada)
When installing the Tribute with a rear exit, the
minimum area to be covered by floor protection is
under the chimney connector and 2” (51 mm)
beyond each side.