Hearthstone Quality Home Heating Products, Inc
CARINA Series 8910
20
The burner glass media poly-bag that you set aside when you unpacked the fireplace contains the correct
amount of glass material to cover the burner. The entire contents of the bag should be evenly distributed over
the burner tray.
1. Locate the burner in the fireplace insert. Refer to
the adjacent illustration.
2. Starting at one end, pour the glass media onto the
burner tray, keeping the pouring spout on the poly-
bag toward the center of the burner to avoid
spillage of glass pieces over the sides of the
burner. See the adjacent illustrations.
3. Once you have poured all of the glass burner
media into the burner tray, carefully smooth the
glass pieces out so they have a uniform depth over
the entire surface of the burner. When the burner
glass media is properly placed, it should look like
the adjacent illustrations.
4. Note: If a few pieces of glass escape over the
edges of the burner tray during installation, it is not
a problem. They will simply land in the area below
the burner and will do no harm.
With the glass media in place, refit the front glass
panel.
Carefully pick up the glass and glass frame assembly
by grasping the sides of the frame and using your
thumbs and fingers to hold the glass and frame as a
complete assembly.
Place the bottom edge of the frame in its retaining track
on the bottom of the firebox opening, centering the
glass frame left to right in the track.
Then reengage the 4 spring loaded retaining clips, by
pulling them forward and rotating them 180 degrees so
that the bottom angled lip of each clip fully engages in
its corresponding notch on the glass front.
