6
02/22
8105-804C
C. Quick Start Guide
April 05, 2021
QUICK START GUIDE
*Before you plug in this appliance, follow these instructions*
Pr
im
e
1. After the exhaust blower has stopped; quickly turn the dial from OFF to HI two times:
HEAT SETTING
HEAT SETTING
OF
F
HI
LO
HEAT SETTING
HEAT SETTING
OF
F
HI
LO
HEAT SETTING
HEAT SETTING
OF
F
HI
LO
• The LIGHT will turn solid green and pellets will feed. Wait for 2 minutes
• If the LIGHT did not turn solid green:
- Turn dial back to OFF
- Unplug appliance, plug it back in and repeat
Priming is only needed for fi rst fi re or starting fi re on empty hopper.
NOTE:
The prime function is only required during initial set up of the unit, or after the unit has
alarmed out due to an empty hopper. Priming while under normal operating conditions will cause
the fi re pot to overfi ll.
Set
U
p
1. Empty fi re box of
component packet and
any other debris.
Ru
n
1. While thermostat is in RUN mode, the
set temperature can be temporarily
changed by pressing UP.
2. Choose Setting:
**Appliance will not turn on unless target
temperature is a higher temperature than the
room temperature.
• LO – HI*
• Green LIGHT will begin fl ashing
and stove will start
Light
HEAT SETTING
HEAT SETTING
0
-1
-2
-3
-4
+1+2
+3
+4
ON
ALARM
OF
F
HI
LO
Dial
Trim
Control Panel
It may take as long as 10
minutes to achieve a fi re in
the fi re pot. Turning the knob
or thermostat to off during this
time will interrupt the startup
process.
*For
fi rst
fi re,
HHT
recommends running on HI
for fi rst 30 minutes
2. Add pellets and close
lid.
3. Turn DIAL to OFF
4. Plug in the appliance
• Exhaust blower will run for about 45
Seconds (wait for it to stop before
priming)
• Green light will start fl ashing
5. Ensure thermostat is connected properly
per included instructions.
