background image

Hearth & Home Technologies  •  RC100 Wireless Wall Switch  •  2166-391 Rev. C  •  9/10

2

Figure 4.  RC100 Function

6.  Place the cover back on the wall switch and press the 

top button. The red light illuminates if the batteries 
were properly installed. See Figure 4.

To prevent unintended operation when not using your fi re-
place for an extended period of time (summer months, 
vacation, trips, etc):

•  Remove batteries from wall switch.

•  Unplug switching adapter and remove back-up batteries.

ON

ON

OFF

OFF

Programming the RC100 to the Control Module

CAUTION! Risk of burns! DO NOT program the wireless 
wall switch to the control module when fi replace is hot.

•  Verify the ON/OFF/REMOTE switch is in the REMOTE 

position.  Green LED light will blink three times and beep 
once 5 seconds later when ready.  See Figure 5.

•  Using a small item (such as a paper clip) press and 

release the learn button located near the ON/OFF/
REMOTE switch.  See Figure 5.

•  Control module will beep once and LED will blink green 

for 10 seconds. 

•  While the LED is blinking, press the top button on the 

RC100 wall switch.  A double beep will come out of the 
control module to indicate that it has been programmed 
successfully.

NOTICE: Up to three remote controls can be programmed 
into the control module. Simply press a button on the other 
remote controls during the 10 second programming process 
to add another remote into the system.

To clear memory in the control module, use a small item 
(such as a paper clip) to press and release the LEARN 
button. Control module will beep once and LED will blink 
green for 10 seconds  

DO NOT

 press any buttons on the 

remote during the ten seconds that the green LED blinks. 
The memory will be cleared.

Turning On the Fireplace

•  Press the top button to turn the fireplace ON. The 

fi replace will fi rst ignite the pilot. Once the pilot fl ame is 
established the main burner will be lit.  

Figure 3.  Battery Installation

5.  Insert the two CR2032 batteries (supplied) into the cir-

cular slots with the positive side of batteries facing up.  
See Figure 2.

Figure 2.  Mounting Wireless Wall Switch

3.  Ensure that ON/OFF button is fully engaged by press-

ing the side pins down. See Figure 3. 

4.  Secure the wall switch on a fl at wall surface using the 

two screws and wall anchors provided. See Figure 2. 
This device will fi t into a standard size junction box.

PINS

PINS

Installation of Wireless Wall Switch

CAUTION! Risk of Fire! DO NOT install damaged or 
modifi ed components

Warranty will be voided if damaged 

or modifi ed components are installed.

Kit components

: One wireless wall switch, two #6 screws, 

two wall anchors, two CR2032 batteries.

1.  Remove wall switch components from packaging.

2.  Insert  small  fl at screwdriver in the tab located in the 

bottom of the wall switch and twist the screwdriver to 
disassemble the wall switch.  See Figure 1.

Figure 1.  Wall Switch Disassembly

f i r e - p a r t s . c o m

Отзывы: