Hearth & Home Technologies • MEZZO/CRAVE/PRIMO Media Installation Instructions • 2300-945 Rev. N • 7/19
2
WARNING
Risk of Asphyxiation or Fumes.
• Place media according to instructions.
• Do NOT place media in area between glass and
firebox.
• Do NOT place media in a position that they may
fall into area between glass and firebox.
• Do NOT use any media other than the media
supplied with this fireplace.
Fireplace will not function properly.
Gas leak may occur.
WARNING! Risk of Explosion. DO NOT
place media
directly in front of the pilot assembly. Delayed ignition
could occur.
4.
Place an even layer of media around the media tray as
shown in Figure 5.
DO NOT place media on media
placement jig.
PRIMO APPLIANCES ONLY:
Place media in media tray
assembly as directed in chart below. An excessive amount
of media could cause sooting to occur.
5. Remove the screw, noted in Figure 6, from the media
placement jig and carefully lift the jig out of the appliance.
DO NOT allow any pieces of media to fall into the
area in front of the pilot.
Figure 3. Media Tray Components -
PRIMO
MODEL
MAX. # BAGS INSIDE APPLIANCE
(media tray assembly)
PRIMO48/48ST
3
PRIMO60/60ST
4
PRIMO72/72ST
5
BURNER
MEDIA TRAY ASSEMBLY
PILOT SHIELD
TRANSITION MEDIA TRAY
MEDIA PLACEMENT JIG
Figure 4. Media Placement Jig Location -
MEZZO/CRAVE/PRIMO
MEDIA PLACEMENT JIG
Figure 5. Media Placement Jig in Place
Figure 6. Remove Media Placement Jig
SCREW
3. The media placement jig must remain in place while
media is placed on the media tray and around the pilot
bracket.
WARNING! Risk of Explosion. DO NOT
place media
directly in front of the pilot assembly. Delayed ignition
could occur.
6. Place the round media set aside in Step 1 over the pilot
shield and areas uncovered by removing the media
placement jig.
DO NOT allow any media in the 1 inch
area shown in Figure 7 and Figure 8.
