OVER
12
DIFFERENT
MODELS
¹
Begin by plugging your controller into the mat first and then into the power outlet.
Then, power on your mat with the controller. Depending on the model you have, this
is done by pressing a button, turning a dial clockwise, or flipping a switch.
²
To set the desired temperature, press the temperature up button or turn the dial
clockwise on your controller. For certain TAO models, you will have to press the
temperature button first, then press the up button.
3
The LED number on your controller will adjust as you are setting the temperature.
A few seconds after you set it, the number will return to the current temperature of
the mat and increase gradually until it reaches the set temperature. Your mat has an
internal sensor that regulates the heat.
⁴
You may adjust the timer between 1-9 hours. Some controllers can only be set to 3,
6, or 12 hour cycles. Other controllers have no timer and will turn off after 12 hours
automatically. You can also turn off your mat at any time.
⁵
If your mat is a model with PEMF or photon lights there are specific buttons to ope
-
rate them. They can be turned on or off at any time with or without heat.
⁶
When you turn PEMF on, it will run for 20 minutes and then “sleep” for 100 minutes.
This cycle will repeat 3 times while the indicator light stays on. You may turn it off
and on at any time to restart the cycle. PEMF can operate independently to the heat
and photon lights.
We have over a dozen controller models to accommodate a wide variety
of mats. As a result, the controller you have may not be one pictured here.
We always provide the latest model for a particular mat.
CONTROLLER
Find out more at:
HealthyLine.com/controllers
⁷
When you turn the photon light system on, it usually works for 60 minutes and turns
off for 180 minutes. This cycle will be repeated 3 times. At any time, the photon
lights can be turned ON or OFF manually.
⁸
Rest assured, there is no combination of buttons or settings that would disrupt or
damage your mat or controller.
