Armrest can be
fixed at either side
K
I
D
D
C
H
B
E
E
B
B
H
A
C
B
I
A
I
H
L
L
L
H
C
A
A
A
A
E
E
E
J
J
M
C/D
F G
K
E
Assembly Code
A – 1-3/8” screw knobs (6)
B – 2-1/4” screw knobs (4)
C – 2-1/8" short-thread bolts (8)
D – 2-1/4” long-thread bolts (4)
E – Flat washers (10)
F – Bent washers (16)
G – Wingnuts (12)
H – Leg frames (2)
I – Cross-braces (2)
J – Backrest support braces (2)
K – Handrail (1)
L – Plastic molded bench panels (3)
M – Plastic molded backrest (1)
Assembly Instructions
1. Align the cross-brace (I) between the two leg frames
(H). Align the two holes on either side of the cross-brace
(I) with the holes on the leg frames (H). Thread a bent
washer (F) over a 2-1/8" short-thread bolt (C) and insert
through the hole. Place a wingnut (G) on the end of the
bolt and hand tighten loosely. Repeat for the remaining
holes.
2. Repeat step one to attach the remaining cross-brace (I).
3. Lay the three bench panels (L) next to each other on the
floor with the textured surface facing down. Position
the assembled frame on top of the panels and align the
holes in the panels with the holes in the frame. For the
first panel (the one farthest from where the handrail will
be), thread a flat washer (E) over a 1-3/8” screw knob (A)
and insert the screw knob through the hole in the frame.
Hand tighten. Repeat for the remaining hole on this
panel.
4. Lay the long section of the backrest support (J) above
the holes in the frame on the two remaining panels.
Thread a flat washer (E) over a 2-1/4” screw knob (B) and
inset the screw knob into the hole in the backrest
support brace (J), then through the frame. Hand tighten.
Repeat for the remaining holes on the two panels.
5. To attach the handrail (K), align the holes to the
exterior surface of the frame. Note: The handrail
should be mounted on the side of the frame closest
to the backrest. Thread a bent washer (F) over a 2-1/4”
long-threaded bolt (D) and insert through the hole.
Fasten a wingnut (G) on the end of the bolt by hand.
Repeat for the three remaining holes.
6. Hand tighten the wingnuts on all four bolts. To ensure
proper placement, the handrail should be mounted on
the exterior of the frame and should extend above the
plastic bench seat panels.
Caution:
Make sure all screw knobs are tightened securely.
Do not overtighten as it could strip the threads. For your
safety, the four extension legs must always be locked in the
same height position. All pins must be pushed completely
through the pinholes before using.
Note:
If any parts are missing, do not return to the place of
purchase, call 800.622.4714.
Warning:
Do not use if any parts appear to be loose or
damaged as personal injury may result.
Instructions
Adjustable Transfer Bath Bench
Item # 522-9821-1900
CAUTION
This product contains natural rubber latex,
which may cause allergic reactions.
Weight capacity: 250 lbs.
