HealthSmart 04-610-001, Инструкция по эксплуатации

Страница: 8 / 19

Troubleshooting
15
If any abnormalty occurs during use, please check and correct the following:
Condition Correction
Display is blank when power is on. Check and correct the polarity of the installed
batteries. Reinstall or replace batteries.
Measurement incomplete or Review and follow “Applying Your Blood
abnormally low or high values Pressure Cuff” and “Taking Your Blood Pressure
displayed. Reading” sections. Replace the batteries.
EE symbol displays. Do not talk or move during the measurement.
Review “Applying Your Blood Pressure
Cuff” section.
Measurements are different from Remember, blood pressure readings are
those typically measured by influenced by physical and mental conditions
physician or every measurement and/or even the time of day. Daily
reading is different. measurements should be interpreted
by your physician.
Indicates a measurement
within Stage 3 Hypertension.
Indicates a measurement
within Stage 2 Hypertension.
Indicates a measurement
within Stage 1 Hypertension.
Appears when batteries should be
replaced.
Shows the pulse rate per minute.
Occurs when an error was made
during measurement.
Appears when there is an irregular
heartbeat detected during
measurement.
Appears when the unit is ready or a
measurement error has occurred. Restart
the measurement if an error occurs.
Appears when the cuff is unstable or it
has too much air left in it. Once the arrow
stops flashing, the unit is ready to take a
measurement.
Appears when recalling a
measurement from memory.
DIA
SYS
DIA
SYS
DIA
SYS
Description of Display Symbols
14
You can recall up to 60 total measurements in memory. These measurements
can be shared with your physician or trained healthcare professional.
1. Press and release the MEMORY button. It will show how many
measurements are stored within the bank, followed by the last
result,
Fig. 1 .
2. Press the MEMORY button again to scroll through the saved measurements.
After you’ve scrolled through all the readings, the unit will automatically
turn off.
NOTE: When the number of readings exceeds 60, the oldest data will be
replaced with the new record.
To erase all stored measurements:
1. Press and release the MEMORY button. The unit will display how many
measurements are stored within the bank.
2. Press and hold down the MEMORY button until two horizontal lines flash.
This indicates that all measurements have been erased, Fig. 2 .
Fig. 1
Fig. 2
Recalling Measurements in Memory