8
Using the Tamper
The Tamper is useful when preparing thick or frozen mixtures.
The Tamper can be used while the machine is running.
1. Make sure Lid is secure and locked in place.
2. Remove E-Z Lock Cap from Lid.
3. Insert Tamper through the opening in the Lid.
4. Hold the Pitcher handle with one hand,
grasp Tamper with the other hand.
5. Move up and down or in a circular motion
to move contents around the Blade.
Tips for Using the Tamper:
When preparing thick mixtures that don’t circulate freely, insert the
Tamper and move in a circular motion. This will help remove any air
or ingredients trapped by the Blade. The Lid prevents the Tamper
from making direct contact with the Blade.
NOTE: In the event the motor overheats during operation
it will automatically shut off. To restore power, allow it to
cool down for 35 minutes before using.
Controls
ON/OFF Button: Push once for ON. Push once for OFF.
The button lights up BLUE when the HealthMaster is
plugged in. It is ON when the LED Display is illuminated.
SPEED Selection: Use the (+) and (-) buttons
to select the speed, 1 through 8.
TIME: Use the (+) and (-) buttons to select the
amount of time in minutes, 0 through 10 minutes.
A time must be selected in order for it to run on
the RUN setting. If you have to blend for less
than 1 minute, manually stop the unit by
pressing the STOP button.
PULSE: Press and release to get a single burst
of speed for each pulse until you have achieved
the desired results. The button lights up BLUE
when activated.
RUN/STOP: Press RUN/STOP to start the
HealthMaster. If the speed was not set,
the HealthMaster will run at speed 1.
The button lights up BLUE when activated.
You must press RUN/STOP again to stop. A time must be selected
in order for it to run on the RUN setting. If you have to blend for less
than 1 minute, manually stop the unit by pressing the STOP button.
ICE: Pressing the ICE button causes the HealthMaster
to operate on a cycle of 1 second on and 4 seconds off.
The button lights up Blue when activated. Press ICE
again to stop.
Attention: The unit will not run on the RUN setting unless a time is selected. If you have
to blend for less than 1 minute, manually stop the unit by pressing the STOP button.
Meijer.com
