HealthCare International RehabMill, Руководство пользователя

Страница: 26 / 32

27
c. After adding, build up the treadmill and start it with the speed 1Km/h.And with one foot tramples the
running belt slightly for several minutes, to let the running belt absorb the lubrication well.
2. Adjustment for Running belt tension
All treadmills’ running belts have been adjusted before they are sent out from factory. And they must be adjusted
for second time after building up .
But maybe after a long time using; the running belt is getting a little loose . And Slipping may occur. When
User faces this occasion, User can simultaneously turn the two screw bolts for adjusting running belt
clockwise ,with the unit ,half a circle.
But don’t turn the screws excessively. Or it will increase the load of motor, do harm to motor, running belt and
rollers.
3. Adjustment for Running belt balance
All treadmills’ running belts have been adjusted before they are sent out from factory. And they must be adjusted
for second time after building up .But maybe after a long time using; the running belt is getting a little unbalanced.
The following reasons which may cause this occasion:
a. The treadmill is placed unsteadily.
b. When running, User does not run at the centre of the running belt.
c.
When running, User’s two feet force is unbalanced to the running belt.
Adjustment:
A. Let the running belt work for minutes without anything or anybody on it. If this does not work, please
follow B guide.
B. Adjusting the screw bolts for running belt by following procedure with the 5mm Allen wrench tool .
1. Place machine on even floor stably.
2. Turn on the machine and keep the speed around 5-6KM/Hour
3. Using the M5 Allen Wrench to insert into the hole sit at the Rear Bottom Cap as shown
below picture, then judge which situation happened and choosing the solution by
following indication and diagrams.
a .
When running Belt is leaning to right side too much
, please insert the M5
Allen Wrench into the Right side of Rear Bottom and turn clockwise .
b.
When running Belt is leaning to left side too much
, please insert the M5
Allen Wrench into the Left side of Rear Bottom and turn clockwise .
4. Please wait for 15 seconds after every adjustment , if the running belt doesn’t came back
to the center of Platform , please repeat procedure a or b.
Caution:
Be sure not to tighten the running belt excessively, otherwise it may speed the decade of
running belt. And the unbalance of the running belt will do
harm to running belt badly.
User must pay more attention to this and adjust it in time.
Note:
Running belt deviation does not belong to guarantee range. It can be adjusted by User in accordance with
the above instruction.