background image

DRAFT COPY

© 2003 DESA Specialty Products™

598-1145-00

Multi-Channel

Remote Control

Features

• Operational range of up to 100 feet.
• Controls all Heath

®

/Zenith Remote Home™ products.

• FCC/IC tested and approved.
• Flash control on compatible receivers when using the Panic

feature.

Battery Cover

Two AAA

Batteries (Not

Included)

Installing 2-AAA Batteries

ALL ON

ALL OFF

OFF

DIM

PANIC

A

B

ON

GROUP

(Dip Switch 4 in

DOWN position)

(Dip Switch 4 in

UP position)

1  2  3

1  2  3

1  2  3

1  2  3

1  2  3

1  2  3

1  2  3

1  2  3

A

B

Setting Receiver(s) Dip Switches

The Control Panel transmitter has
preprogrammed dip switch settings for each
channel. In order for the Control Panel to
communicate with a receiver, the dip
switches on the receiver must correspond
with the preprogrammed dip switch settings
of the channel you wish to use. 

Note: There

are no dip switches on the Control Panel
that require setting.
1.

Determine which receiver(s) will be
operated by which channel.

2.

Set receiver(s) dip switches 1, 2, and 3
to match the dip switch settings for the
channel you wish to operate the
receiver(s).

3.

Determine whether the receiver(s) will
be in Group A or B.

4.

Set dip switch 4 on the receiver to the
same setting as Group A or B.

Preprogrammed Dip Switch

Settings for Remote Control

(Included on Back of Product

as a Reference)

Battery Installation

The Multi-Channel Remote Control is de-
signed for 3 Volt operation:
1.

Remove battery cover on rear of hous-
ing by pushing clip and lifting up.

2.

Install  2-AAA batteries (not included)
according to polarity markings.

Содержание Zenith

Страница 1: ...with a receiver the dip switches on the receiver must correspond withthepreprogrammeddipswitchsettings of the channel you wish to use Note There are no dip switches on the Control Panel that require setting 1 Determine which receiver s will be operated by which channel 2 Set receiver s dip switches 1 2 and 3 to match the dip switch settings for the channel you wish to operate the receiver s 3 Dete...

Страница 2: ...ht as units are turned off To perform this function select either Group A or Group B then press ALL OFF If lights are on or dimmed where applicable they will be turned off PANIC Turns ON all light fixtures programmed for either Group A or Group B Light fixtures within the selected group that have Flash capability will FLASH when this command is received Either Group A or Group B LED indicator will...

Страница 3: ...ller 2 Wrong group or channel is selected 3 Signals from controller are beingblocked ortransmit ter is out of range 4 Batteries are weak Troubleshooting Guide SYMPTOM Remote con trol does not come on Remote con trol will not op eratereceiver Technical Service Do Not Send Products Ifyouexperienceaproblem followthisguide YoumayalsowanttovisitourWeb site at www desatech com If the problem persists ca...

Страница 4: ...E FIT FOR ANY PARTICULAR PURPOSE OR USE AND SPECIFICALLY IN LIEU OF ALL SPECIAL INDIRECT INCIDENTAL OR CONSEQUENTIAL DAMAGES REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE PART OF DESA SPECIALTY PRODUCTS FOR ANY SPECIAL INDIRECT INCIDENTAL OR CONSEQUEN TIAL DAMAGES INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS WHETHER OR NOT FOR...

Отзывы: