DRAFT COPY
© 2003 DESA Specialty Products™
598-1145-00
Multi-Channel
Remote Control
Features
• Operational range of up to 100 feet.
• Controls all Heath
®
/Zenith Remote Home™ products.
• FCC/IC tested and approved.
• Flash control on compatible receivers when using the Panic
feature.
Battery Cover
Two AAA
Batteries (Not
Included)
Installing 2-AAA Batteries
ALL ON
ALL OFF
OFF
DIM
PANIC
A
B
ON
GROUP
(Dip Switch 4 in
DOWN position)
(Dip Switch 4 in
UP position)
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
A
B
Setting Receiver(s) Dip Switches
The Control Panel transmitter has
preprogrammed dip switch settings for each
channel. In order for the Control Panel to
communicate with a receiver, the dip
switches on the receiver must correspond
with the preprogrammed dip switch settings
of the channel you wish to use.
Note: There
are no dip switches on the Control Panel
that require setting.
1.
Determine which receiver(s) will be
operated by which channel.
2.
Set receiver(s) dip switches 1, 2, and 3
to match the dip switch settings for the
channel you wish to operate the
receiver(s).
3.
Determine whether the receiver(s) will
be in Group A or B.
4.
Set dip switch 4 on the receiver to the
same setting as Group A or B.
Preprogrammed Dip Switch
Settings for Remote Control
(Included on Back of Product
as a Reference)
Battery Installation
The Multi-Channel Remote Control is de-
signed for 3 Volt operation:
1.
Remove battery cover on rear of hous-
ing by pushing clip and lifting up.
2.
Install 2-AAA batteries (not included)
according to polarity markings.
