HEALTH RIDER HRTL08980, Руководство пользователя

Страница: 17 / 22

17
PROBLEM SOLUTION
a. If the walking belt has shifted to the
left, first remove the key and UNPLUG
THE POWER CORD . Using the allen
wrench, turn the left rear roller adjustment
bolt clockwise, and the right bolt counter-
clockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in
the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is centered.
b. If the walking belt has shifted to the right,
first remove the key and UNPLUG THE
POWER CORD . Using the allen wrench,
turn the left rear roller adjustment bolt
counterclockwise, and the right bolt clock-
wise, 1/4 of a turn each. Be careful not to
overtighten the walking belt. Plug in the
power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is centered.
c. If the walking belt slips when walked on,
first remove the key and UNPLUG THE
POWER CORD . Using the allen wrench,
turn both rear roller adjustment bolts clock-
wise, 1/4 of a turn. When the walking belt
is correctly tightened, you should be able
to lift
the edges of the walking belt 3 to 4
inches off the walking platform. Be careful
to keep the walking belt centered. Plug in the power cord, insert the key and run
the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
a. If error code ÒE1,Ó ÒE2,Ó or ÒE3Ó appears in the SPEED display, remove the key,
wait for ten seconds, and then reinsert it. If the error code appears again, call our
Customer Service Department.
Do not operate the treadmill until the problem
is corrected.
b. Error code ÒE4Ó may appear in the SPEED display if the walking belt is moving at
a slow speed and there is excessive stress on the motor. If this occurs, remove
the key, wait for ten seconds, and then reinsert it. If you weigh over 200 pounds,
it may also be helpful to increase the incline of the treadmill. If the error code
appears again, call our Customer Service Department.
Do not operate the tread-
mill until the problem is corrected.
a. Use a color-fast upholstery cleaner to clean the walking belt. Test the
cleaner on a small area before cleaning the entire belt.
a. Due to variations in humidity and temperature, there is a possibility that
bubbles may form in the walking belt. Although the bubbles will disappear with
time, you may unplug the power cord, carefully insert a needle into the bubbles,
and push the air out of the bubbles.
a
b
c
4. The walking belt is
off-center or slips
when walked on
5. An error code (ÒE1,Ó
ÒE2,Ó ÒE3,Ó or ÒE4,Ó)
appears in the SPEED
display
6. The walking belt
becomes soiled
7. Bubbles form in the
walking belt