- 3 –
Reset
If some gears are not indicated correctly, reset the unit and setup it up again.
If you have a SpeedoHealer (or other speedometer calibrator) and you change
the calibration factor, probably you have to reset the GIpro and set it up again.
Cut off the power of the unit 6 times in a row, while the GIpro display is
counting up and shows 3, 4 or 5.
You can power on/off the display by flipping the engine RUN switch on/off.
On the next power up, the display will count backwards (6 to 1).
The memory is clear now and you can perform the Setup procedure.
Troubleshooting
Disconnect the GIpro connector and check whether the pins are broken, bent or
pushed out of position. Reconnect the plug, and make sure that all connections
are good and the connector is fully seated.
Make sure the GIpro plug is not loose in the diagnostic connector. Use the long
cable tie supplied to secure the plugs together.
If you can not execute the Setup procedure, your battery might be old or weak.
Charge the battery or connect another battery using a jumper cable.
If some gears are not indicated properly when the engine is running and clutch is
released, reset the unit and setup again.
If the problem persists, your clutch might be slipping.
Warranty
The unit is completely sealed and epoxy encapsulated, which gives extreme
protection for the internal parts from shocks, vibrations and water.
To ensure trouble-free operation from the start, all units have been extensively
tested prior to shipment.
Our dealers are offering a 30-day money-back guarantee on HealTech products,
thus you will get your money back if the product does not fulfill your
expectations.
(All parts must be returned in original condition for full refund.)
Furthermore the product is covered by our 2-year replacement warranty from
the date of purchase
.
Web:
www.gi-pro.net
