Wolfpack Component Video Matrix Switchers
Setup Menu Options
Setup Item
Description
SET: Panel LED
Controls the front panel button LEDs. Default is
ON
.
SET: Disp Lamp
Sets the display brightness to 1 of 4 levels. Default
is
100%
(full brightness).
SET: AC PowerUp
Controls what the matrix does when AC power is
first applied, and how it recovers from a power
outage.
ON
(default) forces the unit to turn on, and the
previous switch state will be restored.
STANDBY causes the unit to enter Standby mode
when AC power is applied.
SET: Touchpanel
Enables or disables the front panel buttons.
Default is
ON
(enabled).
SET: Touchsense
Controls the sensitivity of the front panel buttons.
Default is
HIGH
for fastest front panel response. A
lower setting reduces the risk for accidental button
pushes or false triggers by outside interference.
SET: Front IR
Enables or disables the front panel IR sensor. Set
to OFF to prevent spurious IR signals from
controlling the matrix. Default is
ON
(enabled).
SET: Verbosity
Default is
ON
, where the matrix echoes responses
to any command (via serial, IR, or front panel).
When set to OFF, the matrix only echoes
responses to serial commands.
Note: Memory commands and mute commands will
always echo serial responses, regardless of this
setting
SET: Eco Mode
Economy Mode -This feature controls the power to
the active Cat5 receivers at the displays. ON
means you are in economy mode, and the Cat5
receivers will not function.
OFF
(default) means
that you are NOT in ‘Eco’ mode, and everything is
powered up.
SET: PS in A/B
This must be set to match the configuration of your
power supplies. PS A is the top unit, PS B is the
bottom unit. Set to either A, B, or Both depending
on your system. Normally this will be preset from
the factory.
