Disclaimer:
3
rd
party and/or custom firmware providing extra features are not covered in this manual.
37
4K Vertex² – User Manual
[DHCP]:
When set to ON, Vertex² will retrieve a dynamic IP automatically.
[mDNS]:
Set ON/OFF mDNS support for you router/network capabilities and security settings.
[CURRENT IP CONFIGURATION]:
Display the current value of IP address, IP mask and IP gateway and
MAC address.
[CONFIGURE STATIC IP]:
Enter the IP address, IP mask and IP gateway of your choice for a static IP
setup, DHCP needs to be OFF for using static IP values
[SET IP]:
After any changes in IP configuration, click SET IP to validate.
[IP PORT]:
Set the IP/telnet port of your choice here (default value is 2220).
[SET PORT]:
Click here to apply the IP/telnet port of your choice (Reboot or Power cycle required)
[REBOOT UNIT]
: Click REBOOT button to restart Vertex² completely.
[EXPORT CONFIG]:
Allow you to export a text file that includes the full list of Vertex² settings and some
setup information that can be useful for support.
[ISSUE HOTPLUG]:
Click Send button to perform a soft-reset in your setup.
[CLEAR ALL SETTINGS TO FACTORY DEFAULTS]:
Type
RESET
in the factory def text field and click the
available RESET button to clear all settings to factory defaults. Vertex² power cycle needed.
[EDID FACTORY SETTINGS]:
Click the available check box to clear all EDID settings to factory defaults and
type
RESET
in the test field. Finally click the
RESET
button and unit EDID will be reset to factory defaults.
[FW UPDATE]:
Select the Vertex² firmware file and click SEND to upload it. Wait for Vertex² to reboot
automatically, once Vertex² is rebooted, refresh the webserver page.
[REFRESH]
: Refresh the current page.
