HDelity 2801, Руководство пользователя

Страница: 8 / 10

Determine DIP switch settings if appropriate ( Using Multiple Sources).
Connect the HDMI® source device’s output to the HDMI INPUT connector of the 2801 Transmitter, using a
short, high quality, HDMI cable.
Connect a correctly terminated and tested Cat 5e/6 cable to the ETHERNET connector of the Transmitter. Do
not connect the AC adapter until the UTP cables are correctly connected to both the transmitter and the
receiver.
Again, always test the HDMI source on the intended display with a known good HDMI cable before connect-
ing the distribution system. This precaution insures that the source can be (and is) set to a resolution that is
Compatible with the display, and that both are functioning correctly together.
At remote locations, connect the appropriate UTP cable to the ETHERNET connectors of the 2811 Receiver.
Connect the HDMI OUTPUT of the 2811 to the HDMI input of the video display or other device, using the
appropriate cable. Connect IR equipment (if used) at this time – see below.
Connect the supplied AC adapters first to the 2801 Transmitter and 2811 Receivers (and to any Ethernet
Switches) and then to the AC outlets.
Turn on the source device and video displays. The source video signal should appear on the displays. If not,
consult the Troubleshooting guide.
1.
2.
3.
4.
5.
6.
7.
6
CONNECTING THE HARDWARE
Transmitter (2801)
Receiver (2811)