EX50
3.
4.
Short-run adjust switches (See
)
5.
Power
6.
IR receiver port
7.
IR transmitter port
8.
HDMI over Cat connection from transmitter
First time setup
Your HDanywhere extenders are designed so that you can set them up quickly and start using them right
away.
Before you connect up your system, please ensure that you complete the
following:
●
Switch off any manufacturer HDMI link, HDMI control or CEC protocol settings, such as Samsung
Anynet Link, Sony Bravia Link and Panasonic Viera Link, on both the source devices and HDTVs
that are to be connected to system. These protocol settings are likely to be found in the HDMI
menu settings of the devices you are using.
●
After you have changed the CEC setting, switch off all your HDMI source devices and HDTVs and
unplug them from the mains.
●
Please ensure that you only connect and disconnect HDMI cables while the transmitter and
receiver is powered off.
Powering on the extenders for the first
time
The very first power on/initialisation of the extenders is crucial to their future operation and
performance**.
●
Connect the Cat cable between the transmitter and receiver.
●
Power the HDTV on at the mains. Bring it out of standby mode.
●
Connect the power cable to the HDMI over Cat receiver and power it on at the mains switch.
●
Power on the HDMI source device at the mains and bring it out of standby mode. (NB Sky+HD
takes one minute or so)
●
Connect the power cable to the HDMI over Cat transmitter and power it on at the mains switch.
●
Select the correct HDMI channel that the HDMI over Cat Receiver is connected to
Completing your set-up
After completing the process above, the HDTV should be displaying the HDMI source device video and
audio. Under normal operation the power and link LED’s will be solid blue.
HDanywhere.co.uk
