HDanywhere DDSIGNALMANAGER, Руководство по эксплуатации продукта, Страница: 8 / 12

Help is only an email away: support@hdanywhere.com . 8
Serial communication over USB
It is possible to communicate with the device over serial. This is achieved by using
a USB with a micro USB connector. Serial to USB is managed internally and the
driver (universal CH340 on Windows Operating System) should automatically
install once connected.
The HDMI (OUT) ports A and B on the device casing are addressed using numbers
1 and 2 when using serial comms.
H Help
STA System status
SET RST Reset to factory defaults
SET ADDR [XX] Set device address to XX (00-99) 00=Single
SET ARC ON/OFF Enable or disable ARC
GET ADDR Get device address
GET ARC Get ARC status
GET STA Get device status
GET IN1 SIG STA Get input & signal status from HDMI (IN) port
SET OUT[X] EXA EN/DIS Set extracted audio output to enabled or disabled (X=0, 0=ALL)
SET OUT[X] STREAM ON/OFF Set output [X] stream on/off (X=0-2, 0=ALL)
GET OUT[X] EXA Get status of extracted audio output enabled or disabled (X=0, 0=ALL)
GET OUT[X] EDID DATA Get output [X] EDID data (X=0-2)
GET OUT[X] STREAM Get output [X] stream on/off status (x=0-2, 0=ALL)
Serial settings:
Baud rate: 57600
Bit number: 8
Checksum/Flow/Parity: None
Stop bits: 1