Page 1 (1)
User manual /
Assembly instructions
Cover for push bar
MANUFACTURER: Hantverksdesign & Rehabiliteringsprodukter AB
Tryffelslingan 4, SE-181 57 Lidingö, Sweden
tel. +46 8 767 04 80
fax. +46 8 767 50 00
www.hdrehab.se [email protected]
Rev.
C
Latest revision: 2012-09-19
Art.no. 95171-1
Parts included:
Assembling
The covers are fitted on the pushbar as shown in
figure 1. Before assembling, the push bar has to
be removed from the wheelchair.
1. Undo and remove the screws (1). See figure 1
and 2.
2. Pull out the pushbar (2) from the frame
according to the arrows in figure 2.
3. Use mild soap solution to wet the inside of the
covers (3) and slip them on the pushbar (2) as
shown in figure 3.
Note:
It takes a couple of hours, or up to one day, until
the covers are completely dry and firmly attached.
4. Reattach the pushbar (2) to the frame by
pushing it in place and fasten the screws (1)
according to figure 4.
Note:
Be careful when fastening the screws since the
aluminium threads are fragile.
5. Check that the push bar is properly attached
before using the wheelchair.
Use and Care instructions
The covers can be cleaned by wiping
with normal all-purpose cleaners or hand
disinfection. For further information, see the
Maintenance Instructions, art. no. 95730-1.
2 pcs:
1
2
1
2
1
3
2
3
1
2
3
4
