H B X W A V - 0 1 1 0 O u t d o o r W i r e l e s s S e n s o r
V e r s i o n 1 . 0
© HBX Control Systems Inc. 2015
Page 3
HBX WAV-0110 WIRELESS OUTDOOR
SENSOR
Introduction
This manual will help with the installation, parameter
setting, troubleshooting and general maintenance
requirements for the Controller. To guarantee the
safe and reliable operation of this Control, you must
first read this manual in detail and take particular note
to any and all warnings or caution directives prior to
connecting to AC power.
Only suitably qualified individuals with formal training
in electrical and HVAC controls should attempt the
installation of this equipment. Incorrect wiring and
installation will affect the warranty provided with this
unit. Wiring must be completed in accordance with the
codes and practices applicable to the jurisdiction for the
actual installation.
The HBX WAV-0110 is a microprocessor based
controller and as such is not to be regarded as a safety
(limit) control. Please consult and install the heating or
cooling appliance in accordance with the manufacturer’s
recommendations.
SAFETY SYMBOLS AND WARNINGS:
Extreme Hazard -
This action poses a serious threat that could
result in personal injury or death, as well
as permanent damage to the equipment.
Proceed with caution.
Moderate Hazard -
This action may cause personal injury or
have adverse effects on the installation
process if handled incorrectly.
Disconnect Power Source -
The presence of low voltage(24VAC) or high
voltage(120VAC) could result in personal
injury or permanent damage to components
or equipment.
Point of Interest -
This point clarifies pertinent information,
or brings your attention to an action that
may have adverse effects on the installation
process.
RECEIVING, INSPECTION
AND STORAGE
This HBX WAV-0110 has gone through rigorous quality
control tests at the factory before shipment. After
receipt and before installation perform the following
checks:
Receipt
After receiving, inspect the unit for any possible
physical damage that may have occurred during
transportation.
Inspection
After unpacking the unit make sure the box contains:
• 1 x Base Unit
• 1 x Outdoor Unit
•
2.5mm Screwdriver
• 2 x AA Batteries (installed in Outdoor Unit)
•
Instruction Manual
Make sure the part number on the unit corresponds to
the part number on the original box.
Storage
The WAV-0110 should be kept in its original shipping
carton prior to installation. In order to retain the
warranty coverage it should be stored properly:
•
Store in a clean dry place
•
Store within an ambient temperature range of +10ºC
to +40ºC
•
If possible, store in an air-conditioned environment
where the relative humidity is less than 95%
•
Do not store in places where the unit may come into
contact with corrosive gases or liquids
•
Do not store in an area or upon an unstable surface
where it may become damaged due to falling
