GETTING FAMILIARIZED WITH YOUR 2.4GHz RADIO SYSTEM
2
BATTERY INSTALLATION
1) Slide the battery cover as shown , and according to the
illustrations of polarities, install 3pcs of AA size batteries.
2) Replace the battery cover after batteries are installed.
-Use batteries of same type.
-Remove batteries from the case if not in use.
-Always check the battery power.
-Dispose of exhausted batteries properly.
NOTES:
Your 1/24th scale rock crawler is equipped with the 2.4GHz radio system .Please read and
understand all instructions below before operating.
,
A: Steering Wheel
B: Trigger
C: Battery Case
1: Steering Trim
2: Steering Reverse
3: Red Indicator
4: Power Switch
5: Steering Dual Rate
6: Throttle Trim
7: Throttle Reverse
8: Green Indicator
9: Bind/Mode
Steering Wheel:
It proportionally operates the model s right and left steering control.
Battery Case:
It requires 3pcs of AA size batteries.
Power Switch:
It is used to turns the radio controller ON/OFF
Steering Dual Rate Dial:
It allows you to change the amount of steering servo travel compared to the amount
of physical movement of the steering wheel.
Throttle /Steering Trims:
They are used to adjust the center trim of the throttle/steering channel.
Steering Reverse:
It allows you to electronically switch the direction of steering servo travel. For example,
if you move the steering wheel to the right and the steering servo moves to the left,flip the Steering Reverse
Switch to make the steering servo move to the left.
Throttle Reverse :
It allows you to electronically switch the direction that the motor operates in relation to the
throttle trigger. For example, if you pull the throttle trigger to accelerate forward, but the model goes in reverse,
flip the Throttle Reverse Switch to make the model accelerate forward.
button:
It is used to change steering modes of your car.
Trigger:
Pull it to accelerate, release it to decelerate,and release it to Centre to stop the car. Release it to
Centre and then push it to allow the car to go backwards.
Indicators:
It shows battery power level.Green indicator flashing means battery power is not enough.
As long as bothred and green indicator goes flashing indicating that the radio controller runs out of battery
power, you must replace with fresh batteries immediately.
Bind/Mode
