HBM WE2108 Series, Справочное руководство

Страница: 44 / 72

44
WE2108
HBM A1632-2.0 en
6.2 Special applications
Further functions having influence on the weight indication of the WE2108 are
listed below. The settings can be relevant for legal for trade approval, there-
fore changes are not possible with the access lock activated (exception: filter
setting). The parameters are set ex works to standard values. You therefore
do not need to make any changes if the corresponding function should not be
used.
Further scale types:
Submenu Parameter Meaning
Func tyPE
0: Counting scale
1: One−range scale (set ex works)
2: Two−range scale
3: Two−interval scale
The following applies for two−range / two−interval scales:
Submenu Parameter Meaning
Func
rES−1 Range 1: Scale interval
CAP 1 Range 1: Nominal load
rES−2 Range 2: Scale interval
CAP 2 Range 2: Nominal load
On calibration in the factory (before transporting to the installation site):
Submenu Parameter Meaning
Func ALt, LAt Calculation of the acceleration due to gravity, see Section 6.5
For scale attachments with linearity errors:
Submenu Parameter Meaning
CAL Lin Characteristic linearization, see Section 6.3
Further functions:
Submenu Parameter Meaning Instructions see Section
FiL F_FiL, Icr Filter 7.1
Func F_tAr Preset tare function 5.1.6 + 5.3.2
In the main
menu P_tAr Preset tare value 5.1.6 + 5.3.2
Func
AutoZ Switch−on zero 5.2.3
ZtrAC Zero tracking 5.2.3
StiLL Standstill monitoring 5.2.3
F_InP Tilt monitoring 7.3