REPLACING PARTS
12
SWEEP HOSE
If a hole forms in the sweep hose, it should
be replaced. Unscrew the mender nut from
the hose and pull the sweep hose off the
cleaner connector. Attach a new sweep hose
to the cleaner connector.
PART NUMBER: AX5000RSHA
DEBRIS BAG
The debris bag should be replaced if it is torn.
PART NUMBER: AX5500BFA
SWIVELS
If a swivel ceases to turn easily or leaks while
the cleaner is running, it should be replaced.
PART NUMBER: AX5000SA
*Jetted swivel PART NUMBER: AX5000JSA
TIRES
The tires are wear parts. When the tires
wear-down to the wear marks replace the
tire.
SIDE ROLLERS
The side rollers are wear parts. When the
side rollers wear-down, replace the side
rollers.
TROUBLESHOOTING
13
PROBLEM
CAUSE
SOLUTION
Slow or no forward move-
ment
Low or no water pressure
Check filtration and booster
pumps, valves, cleaner
connections. Check Cleaner
pressure.
Cleaner does not reach
farthest point in pool
Hose too short
Check hose length
Hose frequently tangles
Float not properly placed
Check float is centered on
the two-foot hose connected
to the pipe closest to the
cleaner
Hose too long
Check hose length
Sweep hose not moving
Check sweep hose for holes
or clogs, increase sweep
hose power.
Sweep hose sprays out of
pool
Sweep hose power too
strong
Reduce sweep hose power
Little or no sweep hose
movement
Sweep hose power too
weak
Increase hose power
Hole in sweep hose
Replace sweep hose
Debris clogging sweep hose Disconnect sweep hose and
flush out
Trivac running on side or
upside down
Heavy debris
Empty Bag
Pressure too high
Check operating pressure
Cleaner cannot climb to the
surface in TOP mode
Pressure too high or too low Check operating pressure
Too much heavy debris in
bag
Empty bag
Cleaner runs in small circles Hose on hose cleaner end
assembly bent
Layout in sun until straight
FOR TECHNICAL ASSISTANCE
CALL: 1-800-227-1477
SWEEP HOSE ROLLERS
OUTER GROOVE
The Sweep hose rollers are wear parts.
When the rollers wear-down to the outer
groove (wear line) replace the wear roller.
wear marks
