7
Pool Vac Ultra
IMPORTANT TIPS
In one piece fiberglass pools there is very little dirt on the walls, but the Pool Vac Ultra will still climb the walls.
Due to the shape (severe angles) of most in-ground vinyl liner pools, the Pool Vac Ultra 's cleaning is mostly
confined to the bottom (both shallow and deep) and the hopper sides. However, normal dirt and debris do not
adhere to these walls.
DO NOT COIL HOSE
When storing your cleaner the hose sections must be stored straight, not coiled. A coiled hose will create a
memory in the hose that will impede the Pool Vac Ultra's ability to move properly in your pool.
Coiled
hoses are not covered under the Hayward warranty.
When removing the Pool Vac Ultra from your
pool, be sure to grasp the cleaner by its handle, not by its hose, otherwise your Pool Vac Ultra might be
damaged should the hose disconnect from the cleaner.
1. Skimmers come in many configurations and cannot all be described here. Three basic types are discussed
however.
Some skimmers have two (2) holes in the bottom. There might be a valve, float or cover over the holes. Remove
everything in the skimmer, exposing the holes. The rear hole is usually the suction port. In some cases it will be
necessary to use the V094 Regulator Valve to control water flow through the Pool Vac
Ultra
(see Figure 4)
.
Some skimmers have only one hole in the bottom. This suction port is usually controlled by a valve at the filter
system and most likely will not need a V094 Regulator Valve
(see Figure 3)
.
