Installation
INSTALLING YOUR POOL VAC ULTRA IS SIMPLE...
3
Step 4
The hose should reach from the skimmer or dedicated vacuum line to the furthest point in the pool,
plus two (2)
extra hose sections.
(The length of each hose section is four feet.)
This extra length is absolutely necessary
for proper operation of the Pool Vac Ultra.
If the hose is not long enough, it will be necessary to purchase
additional hose sections from your Hayward Pool Vac Ultra dealer. The hose length supplied (40 feet) has been
determined to be sufficient for the majority of pools nationally. If your hose requirement is more than this, you
must obtain additional hose sections for your cleaner to work properly. After the correct hose length has been
assembled, fill hose completely with water. Insert Flow Gauge into the leader hose, then attach the C-Clip of the
gauge onto the first hose section. Make sure the Flow Gauge is under water. (see Figure 2)
Figure 2
V574
FLOW GAUGE
FLOW INDICATOR
(DESIRED POSITION)
FIRST HOSE
SECTION
LEADER HOSE
C-CLIP
POOL DECK/COPING
TO SKIMMER
OR VAC-LOCK
POOL VAC ULTRA
HOSE
VO93C
CONE
ADAPTER
Figure 3
Step 5
Turn the filter system on and allow it to run long enough to
eliminate any air in the system. Connect the V093C
Skimmer Cone to the tapered male end of the vacuum
hose if you are connecting the hose to your skimmer. Then,
insert the cone into the suction port of the skimmer
(see
Figure 3)
or,
if you are using a Hayward Vac Lock, insert
the hose end directly into the Vac Lock without using
the cone.
(Refer to
Important Tips
for more specific
skimmer information.)
MIN
MAX
